Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 7920 Wireless IP Phone - Firmware 7920-4.0-03-01: EAP-FAST

I am planning to migrate wireless IP Phone firmware from 4.0-02-01 to 4.0-03-01, I read the document this new firmware can support EAP-FAST authentication.

I am facing a problem its not getting the PAC from the RADIUS but my laptop clients are able to access the PAC without any problem.

I found the problem only in Cisco Wireless 7920 IP Phones, please help anyone face this issue.

Thanking you,

Ranga Kishore

1 REPLY
Cisco Employee

Re: Cisco 7920 Wireless IP Phone - Firmware 7920-4.0-03-01: EAP-

If using the Cisco Unified controller, then need to increase the 802.1x timeout on the controller, which is mentioned in the release notes @ http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7920/relnotes/rn302.htm#wp169464.

Sounds like you have automatic PAC provisioning enabled already, which is required.

Also would recommend 3.02, which was just released recently.

253
Views
0
Helpful
1
Replies