Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cisco 7921 web page - password ?

It is possible to modify the config of a 7921G through the phones webpage, but the phone is asking me for a password...

I can't find anything in the adminguide so I hope someone can help me further...

Thx

Karl

5 REPLIES
Cisco Employee

Re: Cisco 7921 web page - password ?

The default is admin / Cisco.

By default also the web access is read-only.

Would need to change to full access in the CallManager. Can also manage the web password via CallManager 5.X and later.

But may want to consider using TFTP encryption if so. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp171617.

New Member

Re: Cisco 7921 web page - password ?

Yes, that's it ....

New Member

Re: Cisco 7921 web page - password ?

What about in Call Manager Express? Is there a way to enable phone web 'full' access in CME?

Cisco Employee

Re: Cisco 7921 web page - password ?

See the New and Changed information section of the 1.0(4) release notes @ http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7921g/5_0_1/english/firmware/1_0_0/release/notes/rn7921_4_1030.pdf.

Will state that you can create an ephone template for this.

service phone webAcces 0

webAccess

0 = Full; 1 = Disabled; 2 = ReadOnly

But by default web access is set to full.

Would only get set to read only if it registers to a CM or CME w/ webaccess set to read-only or disabled.

Is set to read-only by default on the CM.

New Member

Re: Cisco 7921 web page - password ?

Thanks...that took care of it.

3913
Views
14
Helpful
5
Replies
CreatePlease to create content