Cisco Wireless Access Point 1252S-G-N - I need help configuring
We have a fe Cisco Wireless access points that i want to replace with the new 1252 modles. it seems that, there aren't much that is configurable based on the little guide that was shipped with the product except for IP address, hostname and Authentication Servers and HDCP which has to be done using console and CLI since this device is not shipped with a default IP Address.
I have not configured one before and was wondering if I can use the config from older Cisco access poits that we have, change the IP and other parameters and it works?
how about the support for N standards?
and how about specifying the speed parameters or codes the string of numbers?
can someone please help me on this new devices so that I understand how to proceed with their configurations?
Re: Cisco Wireless Access Point 1252S-G-N - I need help configur
AP1252 is provided with radios for 2 bands (2,4 and 5GHz). Both support 802.11n draft 2.0. Final 802.11n standard does not exist yet. In case that the final 802.11n standard differs from 802.11n draft 2.0 a lot it might be necessary to exchange radio modules (hardware upgrade). This is probably the reason why AP1252 is modular.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...