I have two AIR-LAP1510AG-N-K9 units that I want to convert to Autonomous Access Points..actually I want to run them as a Wireless Bridge truth be known. I have done some backround reading on Cisco.Com and around the WWW. I am confused as to if this is actually possible with the 1500 series units.
Quote from Lightweight Access Point FAQ document ID:70278
"Note: The 1000 Series APs and the 1500 Series APs are exceptions to this criterion. All the 1000 Series APs and the 1500 Series APs support only LWAPP"
Does anyone know if this can be done? and without access to a WLC?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...