Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Fax connected to FXS get's busy

Hi,

We have a remote site with a 2811 running 12.4(13r)T

There are 4 BRI ports and 2 FXS ports.

I have a fax connected to fxs 0/1/0

The dial-peers are configured like this :

dial-peer voice 7575 pots

destination-pattern 7575

port 0/1/0

The voice-port has the default configuration :

voice-port 0/1/0

!

voice-port 0/1/1

!

I can see when calling the fax number from a mobile phone that the BRI port becomes active

and the fxs goes to ringing :

CHSOSANyonISR#show voice port summary

IN OUT

PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC

============== == ============ ===== ==== ======== ======== ==

0/1/0 -- fxs-ls up up on-hook ringing y

0/1/1 -- fxs-ls up dorm on-hook idle y

0/2/0 1 bri-voice up dorm none none y

0/2/0 2 bri-voice up dorm none none y

0/2/1 1 bri-voice up dorm none none y

0/2/1 2 bri-voice up dorm none none y

0/3/0 1 bri-voice up dorm none none y

0/3/0 2 bri-voice up dorm none none y

0/3/1 1 bri-voice up up none none y

0/3/1 2 bri-voice up dorm none none y

50/0/1 1 efxs up up on-hook idle y

50/0/2 1 efxs up up on-hook idle y

50/0/3 1 efxs up up on-hook idle y

50/0/4 1 efxs up up on-hook idle y

50/0/5 1 efxs up up on-hook idle y

50/0/6 1 efxs up up on-hook idle y

However, I get a busy tone directly after this.

Any help will be much appreciated.

Rgds,

Jeroen

1 REPLY
Community Member

Re: Fax connected to FXS get's busy

sorry, wrong place to post. will port in correct forum

170
Views
0
Helpful
1
Replies
CreatePlease to create content