Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Filtering on CISCO 350 (a)

Hi,

I'm trying to set up filters on a CISCO 350 and am a bit confused with the configuration.

1) Is it so that the "Default disposition" defines how all protocols will be handled while for each protocols defined in the "special cases" in a filter set definition, another action "per protocol" can be defined (kind of :DISCARD ALL but FORWARD only ones in Special cases)

Thanks and best regards,

Guy

2 REPLIES

Re: Filtering on CISCO 350 (a)

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: Filtering on CISCO 350 (a)

You are correct. The default disposition allows you to define the general case. Allowing you to block (default disposition) all, but forward (filter) special cases (filter), or forward (default disposition) all, and block (special cases) special cases

170
Views
0
Helpful
2
Replies