What is the difference between the radio filters and the ETH filters, between RECEIVE and TRANSMIT for both ? I mean when, for instance, would I use the ETH filter rather than the radio filter for a given filter set ?
Ethernet Protocol Filters is for the access point's Ethernet port (wired LAN port), and Radio Protocol Filters is for the access point's radio port. (for wireless clients)..For example, an SNMP filter on the access point's radio port prevents wireless client devices from using SNMP with the access point but does not block SNMP access from the wired LAN...Here is the link which explains that in detail..
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...