I'm getting ready to setup one of our remote sites with wireless access of data only, no voice or customer access. Looks like H-REAP is the solution. Attached is a diagram of one of our remote site's connectivity and actual vlans.
The following details may be helpful to know:
All LAN vlan routing is static with all vlans advertied out on BGP
Workstations DHCP with a local site server
Phones DHCP with one of the local switches
Currently running a 5500 series WLC at Corporate
Plan to use the 1142n or new 3500 APs
Max 3 APs per site
Remote sites run an ISR and 3560G switches
So, how would I configure routing and switching for the AP's data and control?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...