Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

HA N+1 and Mobility Groups

Hi all,

One question, can I have 2 WLC's on different Mobility Groups pointing to the same HA N+1 WLC which is located in one of those Mobility Groups?. I have not seen any note about this on the Cisco documentation I have checked.

thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

From 7.4 onwards AP can fail

From 7.4 onwards AP can fail over to a WLC even they are in different mobility group. So I think this set up should work without any problem.

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/consolidated/b_cg74_CONSOLIDATED_chapter_01110011.html

http://www.cisco.com/en/US/docs/wireless/technology/hi_avail/N1_HA_Overview.html

HTH

Rasika

*** Pls rate all useful responses ****

2 REPLIES
VIP Purple

From 7.4 onwards AP can fail

From 7.4 onwards AP can fail over to a WLC even they are in different mobility group. So I think this set up should work without any problem.

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/consolidated/b_cg74_CONSOLIDATED_chapter_01110011.html

http://www.cisco.com/en/US/docs/wireless/technology/hi_avail/N1_HA_Overview.html

HTH

Rasika

*** Pls rate all useful responses ****

Bronze

Hi,Please check the below

264
Views
0
Helpful
2
Replies
CreatePlease to create content