802.11n relies on several things for increased speed, two of which are multiple spacial data streams (currently two) and the 40MHz increased channel width. When you do point-point, apparently there is just not as much multipoint benefit. She said we would be lucky to see more than 50 Mbps real throughput on a bridge using 1252s at 100m range. BTW, she said that even though the install guide says the 1252s could not be used in bridge mode, she thought it would work; perhaps the 2007 guide is outdated.
So, we are going to get some antennas and test this. Will try to report back on the results.
Regarding Exalt, she did confirm that at present Cisco is re-branding and selling them as OEM and support would be direct through Exalt, not TAC. She would not speculate on looming acqusitions, but did jokingly observe that in the past, all the companies that Cisco absorbed went through an OEM re-sell phase ;p
Re: Is there any 802.11n wireless bridge or some bridge throughp
Entirely correct. A 11n bridge would still benefit of the new modulations and channel bonding if any, so you get 70Mbps (theoretical) throughput instead of 54 more or less and around 150 if you go with 40mhz channel.
The 1250 did not originally support bridging (although it worked), hence the guide you are mentioning. Newer release notes indicate it's now ok to use it as a bridge.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...