Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

leap failure after equipment reboot

Everything worked fine, but afer a power failure all the equipment rebooted (3560, 1100, acs, wlsm).

No 7920 fails to authenticate using leap (cckm+tkip). All configs look ok (all of the had been saved)

PEAP clients and wep client authenticate without any problems.

And one more problem

despite this

dot11/wlccp authenticator:

receive packet debugging is on

transmit packet debugging is on

process debugging is on

dot11:

802.1X module LEAP debugging is on

ldk-d-3ap10#

the only messages I get are

Oct 3 10:41:13.043: %DOT11-7-AUTH_FAILED: Station 0011.21ce.da30 Authentication

failed

Any ideas?

1 REPLY
Community Member

Re: leap failure after equipment reboot

First impression would be that some config wasn't saved.

If using CCKM, need to ensure that 7920 is set to AKM and LEAP username and password are correct.

Would check the ACS logs to see if the request gets there or not. If so, should give a failure reason.

You can attach your AP config for review as well.

196
Views
0
Helpful
1
Replies
CreatePlease to create content