Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
I run a large wlan. however i have a branch site that requires just 1 cisco accesspoint ( i have a spare 1240g ap )
I would like to make this a standalone AP connected to the lan which can manage client authentication and association. It will be connected to cisco poe switch and the site is run by a cisco router.
the laptops will require static addresses.
whats the easiest way to play around with an test a 1240g ap in fat mode ?
also is there any other new ap`s perhaps a 5ghz or n radio device that can be run solo ?
Have you tried using H-REAP?
H-REAP Modes of Operation Configuration Example
H-Reap Design and Deployment Guide
Hybrid Remote Edge Access Point (H-REAP) Basic Troubleshooting
Hope this helps.
thanks for your replyi will read these documents.