Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MERAKI POINT TO POINT BRIDGE MODE

i would like to create point to point bridge using meraki access point. I want to carry vlan 10 from one end of the switch to the other end of switch via AP1 and AP2 resp. How to achieve this, please help with configuration

4 REPLIES

MERAKI POINT TO POINT BRIDGE MODE

You know Meraki offers free phone and online support, right?  In your dashboard just navigate to help > get help.

That said, you should find this helpful:

https://kb.meraki.com/knowledge_base/extending-the-lan-multiple-repeaters-and-wired-clients

-- please remember to rate and mark answered helpful posts --

-- please remember to rate and mark answered helpful posts --
Silver

MERAKI POINT TO POINT BRIDGE MODE

check the link given below for different configurations

https://meraki.cisco.com/lib/pdf/meraki_whitepaper_point_to_point.pdf

New Member

MERAKI POINT TO POINT BRIDGE MODE

Meraki Access Points automatically MESH between each AP in the same Network.

So just add the two APs in the same Network in your Dashboard and thats it.

Please feel free to contact me,

if you have any further questions!

Regards,

Sven

Bronze

Hi,Configure one of your AP

Hi,

Configure one of your AP in NAT Mode/Gateway mode and to 2nd in Repeater mode and then connect Repeater AP with the SSID of Gateway AP.

By this configuration both AP would establish point to point wireless link between them to carry vlan 10 traffic.

7293
Views
0
Helpful
4
Replies
CreatePlease login to create content