I'm working on getting video conferencing working over our wireless infrastructure. I'm using a Cisco 1131b/g access point in "Workgroup Bridge" mode as the interface between a Polycom system and the Wireless network.
I have been able to get the 1131 to connect, however it will not connect at a data-rate over 1 meg. When I change the config of the 1131 to require a data speed higher than 1 meg, the 1131 will not associate.
I've attached a running config for the 1131, and the console messages.
I keep getting the console message:
"%DOT11-4-UPLINK_DOWN: Interface Dot11Radio0, parent lost: Had to lower data rate"
The system had to be able to support a data rate of 384K for video conferencing, and needs to be able to roam through the facility.
The connection to the parent access point on the indicated software was lost for the reason indicated. Then the unit will try to find new parent access point. That's why you are getting this error message.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...