Are there any "best practices" or recommended settings for optimizing voice traffic across a 1351 wireless bridge set? The 2 bridges are approx 200 feet from each other, no obstructions. Link tests from within the IOS show 1% retries and 54MB speed. However - 7920's at the remote location reboot (phones re-register) at least 4 times per day.
I have the bridge configured for Best Throughput. Should I disable to the lower data rates, since the APs are so close and unlikely to need them? That would decrease my "wireless ring" size and prevent interference from weaker signals.
Are there any settings (preamble, packet size, etc.) I should be tweaking in the 1351 settings to optimize voice traffic?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...