Re: Peripheral A/B switch indicates opposite of the Active Side
If a problem is encountered, particularly after replacing an Alarm Arbiter Card (AAC), where the peripheral equipment A/B selector switch(es) indicate
a selection opposite of which side of the VCO is Active (i.e., VCO A side Active - peripheral A/B switch shows B side selected), it may indicate that Jumper J4 on the AAC is installed incorrectly.
To correct the problem, remove the AAC (this requires turning off the VCO power) and locate Jumper J4 as shown in the figure. Ensure the jumper is positioned near Resistor R31 as shown. When the jumper is in the correct position, reinstall the AAC and apply power to the VCO. The peripheral A/B selector switches should now indicate the same side active as the VCO.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...