I have WLC which controls a WLAN that hosts data traffic and VoIP traffic.
I have enabled Platinum QoS profile and the throughput of the WLAN decreases to approximately 10 Mbps (With bronze QoS profile throughput was like 22~25 Mbps).
I would like to know how does the QoS profile limit the throughput of the WLAN? WLC gives a warning that data traffic will be affected but that doesn't tell much about the actual mechanism of traffic limiting.
I used iperf software sending UDP data @ 500 Mbps to measure the throughput.
Is it absolutely necessary that your data and voice clients be on the same SSID? Seems like things would work better if your voice clients were on a platinum SSID and your data clients were on a different bronze/silver SSID.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...