Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

QoS on Bridged Connection

Hello together,

is there a way to prioritize voice traffic over a bridged wireless connection? Currently we use two 1310 bridges in a flat configuration (no vlans, psk, ...).

Thanks for inspirations

Alex

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: QoS on Bridged Connection

Hi Alexander,

Have a look at these docs. Hopefully they will help get you started;

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Software Configuration Guide, 12.3(4) JA

Chapter 14 - Configuring QoS

This chapter describes how to configure quality of service (QoS) on your access point/bridge. With this feature, you can provide preferential treatment to certain traffic at the expense of others. Without QoS, the access point/bridge offers best-effort service to each packet, regardless of the packet contents or size. It sends the packets without any assurance of reliability, delay bounds, or throughput.

From this doc;

http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a00804158a6.html

Giving Priority to Voice Traffic

This section demonstrates how you can apply a QoS policy to your wireless network's voice VLAN to give priority to wireless phone traffic.

In this example, the network administrator creates a policy named voice_policy that applies voice class of service to traffic from Spectralink phones (protocol 119 packets). The user applies the voice_policy to the incoming and outgoing radio ports and to the outgoing Ethernet port for VLAN 77.

Use the Apply Policies to Interface/VLANs drop-down menus to apply policies to the access point Ethernet and radio ports. If VLANs are configured on the access point, drop-down menus for each VLANs' virtual ports appear in this section. If VLANs are not configured on the access point, drop-down menus for each interface appear.

From this doc;

http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a00804158a6.html#wp1047736

Hope this helps!

Rob

Please remember to rate helpful posts.......

2 REPLIES
Hall of Fame Super Red

Re: QoS on Bridged Connection

Hi Alexander,

Have a look at these docs. Hopefully they will help get you started;

Cisco Aironet 1300 Series Outdoor Access Point/Bridge Software Configuration Guide, 12.3(4) JA

Chapter 14 - Configuring QoS

This chapter describes how to configure quality of service (QoS) on your access point/bridge. With this feature, you can provide preferential treatment to certain traffic at the expense of others. Without QoS, the access point/bridge offers best-effort service to each packet, regardless of the packet contents or size. It sends the packets without any assurance of reliability, delay bounds, or throughput.

From this doc;

http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a00804158a6.html

Giving Priority to Voice Traffic

This section demonstrates how you can apply a QoS policy to your wireless network's voice VLAN to give priority to wireless phone traffic.

In this example, the network administrator creates a policy named voice_policy that applies voice class of service to traffic from Spectralink phones (protocol 119 packets). The user applies the voice_policy to the incoming and outgoing radio ports and to the outgoing Ethernet port for VLAN 77.

Use the Apply Policies to Interface/VLANs drop-down menus to apply policies to the access point Ethernet and radio ports. If VLANs are configured on the access point, drop-down menus for each VLANs' virtual ports appear in this section. If VLANs are not configured on the access point, drop-down menus for each interface appear.

From this doc;

http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a00804158a6.html#wp1047736

Hope this helps!

Rob

Please remember to rate helpful posts.......

New Member

Re: QoS on Bridged Connection

you need to run the command auto qos

299
Views
4
Helpful
2
Replies