I am trying to setup Jabber. My problem is that the smart phones do not roam to the next access point until the rssi is so low the person can no longer hear the conversation. Is there any way to force the smart phone to roam sooner?
Romaing is a client based decision, what you can do on the APs is make sure that the overlapp of the cell is not more then 15%, make sure you have used the non overlapping channels 1-6-11 between your access points leaving the units with the same channel the further apart.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...