cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
290
Views
0
Helpful
1
Replies

setting up AP SSO using 5508 controllers located in two different buildings , using a layer 2 connection between the two buildings

atifali.zaidi1
Level 1
Level 1

can i setup ap sso without using RP ports connectivity on 5508 controllers which are located in two different buildings , when the two buildings are connected by a layer 2 port-channel using single mode fiber 

controller 1 - core switch ---------------------------------layer 2 port-channel -------------------------------------core switch 2 - controller 2 

i dont have the option to use , RP port connectivity .

please advise how this could be accomplished ?

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

The RP has to be connected. I have had customers do this but created a layer 2 code mnection just for the RP interface. Since you already have a layer 2 connection it seems to me that adding a vlan across shouldn't be an issue. 

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: