Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
1) point to point only
2) no any voice gateway or callmanager
3) low cost
Is the following design possible ?
(analog phone & ethernet device) - ata188 - wireless bridge 350 -(wireless)- wireless bridge 350 - ata188 - (analog phone & ethernet device)
There is nothing wrong in the topology. The only concern is that ,for the ATA 188 to get a dial tone for the phone, it successfully needs to register with either a Call Manager or Gatekeeper / Gateway.
Thanks for your reply,
So, simply speaking,
when only this configuration - no any callmanager or Gatekeeper ,Gateway.
analog phone(A)-ata188--(LAN)--ata188-analog phone(B)
No can any call each other phone(A) and phone(B) ?