Vlan Config 1242ag/ vlan config HP 2848 Procurve switch
Our new phone system has been put in place as of yesterday, how ever someone forgot to mention that we will have wireless handsets...my main issue is that i can get the phones and the pc clients to connect.
The AP (1242ag configuration attached) is allowing only the native traffice through either if its on vlan 1 or 20.
Vlan 1 is Voice (I know this is a big no no though, The phone co that installed the phone system did not do their homework) and the data is on vlan 20, if i leave vlan 1 native the wireless handsets will connect, and my pc clients are associate with the access point but do not get an ip address only the default on. if i move the native over to vlan 20 the computers get associated and an ip address but the phones will not connect. I am not a cisco god but know my way around the cli interface, and with this issue i am getting better at it. any help would be great.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...