Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Voice chopping and call disconnection on Nortel phones

Recently, i migrated some 350 AP from WiSM-1 to cisco 5508 controller with 7.6.100.0 code version. 

We have 300 nortel wireless phones that was working on old WiSM, now we are not able to hear anything and the calls always disconnecting.

 

Any help appreciated.

Regards

Misbahuddin

 

Additional Information for Nortel Phone

 

TN ID CODE: 2211

 

ISET MAC ADR: 00:90:7A:05:6D:78

ISET IP ADR: 10.127.2.49:5000

LTPS IP ADR: 137.135.128.141

 

MANUFACTURER CODE: 00 [NAME]

MODEL: Nortel WLAN 2211 Handset

NT CODE: NTTQ5010

COLOR CODE: 66

RLS CODE:  7

SER NUM: 056D78

FW/SW VERSION: 097.067

REQ:

DTC001

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

It's looks like this phone

It's looks like this phone model only supporting 802.11b data rates (which is not good at all for voice deployment).

http://www.bcm50.com/WLAN2211.php

Ideally voice deployment is recomended on 5GHz (802.11a).

Not sure whether you have configured wireless QoS properly & prioritise voice traffic in your network. Also in the first place check these phone classify traffic as EF (DSCP value).

With WiSM what version of AireOS software it had ? Make sure configuration migrated as it is.

Anyway post "show wlan <wlan-id>" output  & "show client detail 00:90:7A:05:6D:78" to check some of the configuration details.

 

HTH

Rasika

**** Pls rate all useful resposnes ****

1 REPLY
VIP Purple

It's looks like this phone

It's looks like this phone model only supporting 802.11b data rates (which is not good at all for voice deployment).

http://www.bcm50.com/WLAN2211.php

Ideally voice deployment is recomended on 5GHz (802.11a).

Not sure whether you have configured wireless QoS properly & prioritise voice traffic in your network. Also in the first place check these phone classify traffic as EF (DSCP value).

With WiSM what version of AireOS software it had ? Make sure configuration migrated as it is.

Anyway post "show wlan <wlan-id>" output  & "show client detail 00:90:7A:05:6D:78" to check some of the configuration details.

 

HTH

Rasika

**** Pls rate all useful resposnes ****

76
Views
0
Helpful
1
Replies
CreatePlease login to create content