cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
314
Views
0
Helpful
1
Replies

Voice loss also with signal OK

gbressanin
Level 1
Level 1

Hi,

I have an environment with WISM release 6.0 and 7921 with firmware 1.3.2. This is the issue that I have, when the signal from the AP on the phone display is around 2 step ( 5 step is full signal) the call remains active but the conversation becomes silent. Also when I have only 1 or 2 step of signal I receive the call ( the phone ring ) but I unable to take the call, the keyboard isn't working.

The controller has the DTPC enabled and on the phone the Tx Power is 14 dBm.

Any suggestion?

Thanks

Giovanni

1 Reply 1

gbressanin
Level 1
Level 1

Hi,

I update the WLAN configuration enhanced it with WPA2/AES, before I had only WPA/TKIP. Now seems that the situation has improved.

Before I got a lot of " Decrypt errors occurred for client xx:xx:cc:xx:xx:xx using WPA key on 802.11b/g interface of AP yy:yy:yy:yy:yy:yy , now I get a very few of these kind of messages

Regards

Giovann

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: