Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

VOIP call Failed (Error Code 15) in Prime Event log.

I'm seeing the following events in Prime Infrastructure related to Cisco 7925 phones.

VOIP Call Failed for "(Error Code 15) occurred on client "xx:xx:xx:xx:xx:xx' which was associated to AP <APName> on interface 802.11b/g.

I can't seem to find where this error code 15 is defined.  The closest I was able to find was error code 15 under gatekeeper codes in the following document which may or may not be relavent.

http://www.cisco.com/en/US/docs/ios/voice/monitor/configuration/guide/vt_voip_err_cds_ps6350_TSD_Products_Configuration_Guide_Chapter.html

Any insight into this would be appreciated.

Jake

P.S. No voip call jokes on 802.11b/g please

Everyone's tags (2)
5 REPLIES
New Member

VOIP call Failed (Error Code 15) in Prime Event log.

Were you able to find a resolution for this?  I have the same issue.

Re: VOIP call Failed (Error Code 15) in Prime Event log.

It was funny settings under the Adv WLAN profile on the phone. Reset the offending handsets and reconfigured and they were fine.

Sent from Cisco Technical Support iPhone App

New Member

Re: VOIP call Failed (Error Code 15) in Prime Event log.

Now I'm curious what the funny settings were.  I set mine to use non-overlapping channels for the A and G radios, however, this doesn't appear to resolve it.  I am wondering what settings you found worked.

Re: VOIP call Failed (Error Code 15) in Prime Event log.

It had 18Mbps set as the min phy rate.  I also think it has to do with CAC issues at 18Mbps that are pretty well noted and differeing mandatory rates across the 802.11b/g/n and 802.11a/n networks on the controller.  When the phone would roam onto a radio with 18Mbps was the min mandatory rate, it would drop and give this error.

New Member

Re: VOIP call Failed (Error Code 15) in Prime Event log.

Thanks for the reply!  Mine are set to the default PHY rate, however, it gives me something to double check on the wireless side to make sure it is enabled.

2221
Views
0
Helpful
5
Replies
CreatePlease to create content