Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless E&M

I have two PBXs in two buildings about 100 yards from each other with a good line of sight. How can I link the two phone systems using a radio solution. Ther are only 16 users at the smaller of the two buildings.

What is the best technology?

2 REPLIES
New Member

Re: Wireless E&M

The use of WLAN 802.11b bridges can provide network connectivity up to a data rate of 33Mbps. This will require 3 antenna and bridges per side. The bridge can tie into a switch to provide an Ethernet connection to your PBX’s (as long as there is Ethernet support on your PBX).

New Member

Re: Wireless E&M

Why not install telco T-1 radios? They present native T-1 interfaces that will likely connect directly to your PBXs, with no VoIP, gateways, etc.

Very straightforward, clean solution.

263
Views
0
Helpful
2
Replies
CreatePlease to create content