wireless module

[pcfreak49]

I have a problem I get my wireless module is no longer open get just try 10.10.10.1, 2002 ... open does anyone know why?

[Surendra BG]

use the below command and try once..

service-module wlan-ap 0 session clear

if this doesnt work then

service-module wlan-ap 0 status

see if the module has any problem..

If nothing works then you have to RMA the box

[pcfreak49]

I try to leach in to the wireless module through

service-module wlan-ap 0 session
he demand a username and password
give in and be accepted

R2 # service-module wlan-ap 0 statistics

Module Reset Statistics:
   CLI reset count = 0
   CLI reload count = 0
   Registration request timeout resets count = 0
   Error recovery timeout resets count = 0
   Module registration count = 2

R2 # service-module wlan-ap 0 stat?
statistics status

R2 # service-module wlan-ap 0 status
Service Module Cisco WLAN-AP0
Service Module supports session via TTY line 2
Service Module is in Steady State
Service Module reset on error is disabled
Service Module heartbeat-reset is enabled
Getting status from the Service Module, please wait ..

[abwahid]

Hi,

Try this command

service-module wlan-ap 0 session