Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLAN design for 7920 phone

If I currently have an 802.11g network that has been optimized to support data devices at 36 Mb/s or higher (i.e., AP cells a little closer to maintain higher speeds) and I now want to add 7920 wireless phone support, do I have to re-do my site survey to optimize the WLAN speed for 11 Mb/s by spacing my APs further apart so that channels using the same frequency do not interfere with each other?

Thanks

1 REPLY
Cisco Employee

Re: WLAN design for 7920 phone

With 802.11g radio, would want to set 11mbps to the basic rate and only enable 18-54 or whatever higher rates you want enabled.

Enabling lower rates will extend the cell and vice versa will reduce the cell.

So probably a good idea to re-check the coverage, noise, signal to noise ratios.

150
Views
0
Helpful
1
Replies