Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC QoS settings

Hello all. I have a video surveillance system that must be able to be viewed on the wireless. It uses multicast and I have configured that appropriately (checked with tac). The response time is bad, camera images/frames per second very slow. So I think I need some QoS. I have made the SSID gold on the controller for QoS. What config do I need on AP ports, controller port, etc on my switches (mls qos trust cos or dscp?). Do I need to do anything else?

Thanks,

3 REPLIES

Re: WLC QoS settings

This is what we have on the AP switch ports and uplink trunk ports:

mls qos trust dscp

This is what we have on the switchports to the controller:

qos trust cos

as well as vlan pruning of vlans that do not need to cross the trunk to the controllers

Also, under the controller QOS profiles, do you have 802.1p enabled?

New Member

Re: WLC QoS settings

Thanks, I changed my AP ports to dscp and did enable 802.1p. My concern is right now on the trunk ports it is set to trust cos. We are running Cisco voice, so I am not sure if I can change the trust on the trunks from cos to dscp, any thoughts?

Re: WLC QoS settings

this may help too:

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a0080810880.shtml

Wireless LAN Controller (WLC) Configuration Best Practices

562
Views
0
Helpful
3
Replies