We are running WPAv2 for our CE Symbol handhelds (MC9060). We also run a Spectralink VoIP system at our retail stores. We disabled WMM over the weekend per a Spectralink recommendation and found immediately afterwards our WPA handhelds could not authenticate. Can anyone point me in the direction of an explanation. Another side not we only seemed to see this on our IOSUpdgraded AP's.
Create separate VLANs instead of using migration mode (one VLAN for Wi-Fi Protected Access (WPA) only, and another VLAN without WPA). For more information on the wireless client card, refer to Aironet A/B/G Wireless PCI Adapter. Note: With Funk client, the client does not appear as authenticated under WPA, yet show dot11 association on the AP shows the client as successfully authenticated
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...