Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Adding aIOS AP on WCS/PI/NCS

This Document shows us how to add the aIOS AP on to any NMS device what we have - WCS/NCS/PI

Config on the AP

==============

1>> Configure the Community on the AP with the Community Name With Read/Write (RW) permission

2>> Configure the SNMP host IP address with the community name

Here are the command for the same on the AP..

ap(config)#do sh run | i snmp
snmp-server community <community name> <access level - ro/rw>
snmp-server host <NCS/PI/WCS IP addr> <Community name>

Example

ap(config)#do sh run | i snmp
snmp-server community maibpi RW
snmp-server host 10.106.60.111 maibpi

Config on the PI/NCS/WCS

========================

1>> From the NCS GUI Go to COnfigure >> Access Points

2>> From the Drop Down, Select ADD Autonomoous AP

3>> Fill in the details and hit on ADD

4>> If Added Details are correct then this is how we see on ther PI GUI...

5>> If we click on the AP this is how it looks

TROUBLESHOOTING

===================

>> Just in case if we are failing to add APs,

1>> Make sure the config on the AP is correct and pointring to the right Community and the PI address

2>> Telnet / SSH credentials should be set same on both the AP and the NCS

Version history
Revision #:
1 of 1
Last update:
‎03-15-2013 10:18 PM
Updated by:
 
Labels (1)