Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

B clients cannot connect to the AP, while A and G clients connect without a problem

Core Issue

Data rates are not configured properly.

Resolution

There is a problem with the data rate settings.

To properly connect different client adapters with 802.11B cards, make sure that data rates 1, 2, 5.5, and 11 (mbps) are set to require and that all other data rates are set to enable. The 802.11B cards do not understand the 54 mbps data rate, so the cards do not work if the data rate is set to require on the connecting Access Point (AP).

For more information on configuring the data rates on the AP, refer to the Configuring Radio Data Rates section of Configuring Radio Settings.

For other factors that affect wireless communication, refer to these documents:

Version history
Revision #:
1 of 1
Last update:
‎06-18-2009 03:53 PM
Updated by:
 
Everyone's tags (4)