Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How to configure protocol filtering

Resolution

Protocol filters prevent or allow the use of specific protocols through the Access Point (AP). To configure protocol filters on your AP, perform the steps for the appropriate model AP you want to configure.

Note: Once a filter is created, it must be specifically enabled in the 350 and 1200 series APs, or applied in the 1100 and 1200 series APs. For directions on enabling and applying filters, refer to the instructions in the above-mentioned documents.

Problem Type

Configure / Configuration issues

Products

Access point

SW Features

Protocol filtering

759
Views
0
Helpful
0
Comments