To run the WLAN Controller, perform these initial configuration steps:Following are the Initial config steps to get the Wlan-Controller up and running :
In order to recover the password for the WLAN Controller, Apply the command service-module wlan-controller 1/0 reset in the privilege level mode.
Router#service-module wlan-controller 1/0 reset
Use reset only to recover from shutdown or failed state Warning: May lose data on the hard disc!
Do you want to reset?[confirm] y
This is what one is going to get on the screen while doing a password recovery.
Trying to reset Service Module wlan-controller1/0. r27-2821-1# *Jun 7 05:11:07.223: %LINEPROTO-5-UPDOWN: Line protocol on Interface wlan-controller1/0, changed state to up r27-2821-1#service-module wlan-controller 1/0 session Trying 192.168.99.1, 2066 ... Open Cisco Bootloader Loading stage2.... Cisco Bootloader (Version 220.127.116.11) .o88b. d888888b .d8888. .o88b. .d88b. d8P Y8 `88' 88' YP d8P Y8 .8P Y8. 8P 88 `8bo. 8P 88 88 8b 88 `Y8b. 8b 88 88 Y8b d8 .88. db 8D Y8b d8 `8b d8' `Y88P' Y888888P `8888Y' `Y88P' `Y88P' Booting Primary Image...
Press now [ESC] for additional boot options...
For boot options, choose one of these options:
Choose one of these options:
This is a summary of the procedures:
For more information on configuring the WLAN Controller, refer to the How to Configure the Cisco WLAN Controller Module section of Cisco WLAN Controller Network Module Feature Guide.
For more information on the WLAN Controller module , refer to Cisco Wireless LAN Controller Module Data sheet.
Configure / Configuration issues
Wireless LAN Controller Module (WLCM)