Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How to make minor changes to the Access Point when it crashes and reloads

     

     

    Introduction

    How to make minor changes to the Access Point when it crashes and reloads

    Core Issue

    The Access Point (AP) crashes and reloads during a hostname change running firmware version 12.2(15)XR2.

    Resolution

    To address this issue, refer to these Cisco bug IDs:

    AP 1200 reboots or resets when running with version 12.2.15XR1. The reboots are not predictable in any manner of rebooting. The AP reboot requires two to four hours. The radios that run in the unit are the 802.11a and the 802.11g.

    In the scenario of Cisco bug ID CSCee49659, if a user authenticates at the same time the Command Line Interface (CLI) is used to change the hostname, a reboot can occurred.

    There is not enough information to determine why or when this occurs. There are no bugs reported where changing the hostname causes a crash.

    CSCef50960 Details

    AP1200 reboots/reset w

    AP1200 will reboot or reset when running with the 12.2.15XR1 release. The reboots are not predictable or in any manner of rebooting. The AP are rebooting between 2 to 4 hours time. The radios that are running in the unit are the 802.11a and the 802.11g

    Problem Type

    Continuous reboot

    Products

    AP 340, 350

    Reference

    CSCef50960

    CSCee49659

    886
    Views
    0
    Helpful
    0
    Comments