How to reboot the access point
You can restart the access point by one of the following methods
1. Remove the power and replug the power cable
2. Using the CLI in the ap prompt type boot command. i.e [ap:boot]
3. In the Web interface use the System Configuration Setup page to restart the access point. Use the System Configuration Setup page to restart the access point.
"Warm" Restart System Now
Performs a warm restart of the device. A warm restart reboots the device.
"Cold" Restart System Now
Performs a cold restart of the device. A cold restart is the equivalent of removing and then reapplying power for the device.
Reset System Factory Defaults Except IP Identity
Click this button to reset all of the settings, except
Read Config File From Server
Click this button to send a configuration file from the server to the device.
Browser Update Now
Click this button to send the configuration file you named in the Additional System Configuration File entry field to the device.
Power / cable compliance
Restarting the Access Point