Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

How to Reset the AP through an Airespace Switch

     

     

    Introduction

    How to reset the AP through an airespace switch

    Resolution

    To reset the Access Point (AP) through the airespace switch, perform these steps:

    1. Connect the AP directly to the airespace switch.
    2. Go to Switchweb > Wireless > Airespace APs.
    3. At the bottom of the page there are two buttons. Click Clear config. Then click Reset AP.
    4. The AP reboots. Once the AP LEDs start blinking, unplug the LAN cable. This resets the AP completely.

    Before performing the procedure, ensure that the airespace switch is configured in Layer 2 (L2) mode.

    In this mode, AP does not use the IP address. To configure the switch in L2 mode, go to Switchweb > Switch > General > LWAPP Transport Mode = 'Layer 2".

    Problem Type

    Reset defaults

    Products

    Access point

    Wireless LAN Controllers

    Version history
    Revision #:
    2 of 2
    Last update:
    ‎08-23-2017 09:24 PM
    Updated by:
     
    Contributors