Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

How to troubleshoot LEDs on a wireless bridge

 

 

Introduction

How to troubleshoot LEDs on a wireless bridge

 

Resolution

If your wireless bridge is not communicating, check the three LED indicators on the top panel. You can use them to assess the unit's status quickly.

 

For information on understanding LEDs on the wireless bridge, refer to the following documents:

 

If your bridge is not associating with the remote bridge, check the four LEDs on the back panel. You can use them to quickly assess the unit's status. For information on using the LEDs during the installation and alignment of the bridge antenna, refer to the "Bridge LEDs" section in the Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. Click this link to browse to the Hardware Installation Guide:

 

http://www.cisco.com/en/US/docs/wireless/bridge/1400/installation/guide/1400hig4.html

 

1400 Series Bridge:

 

 

 

 

 

1

Ethernet LED

3

Radio LED

2

Status LED

4

Install LED

 

 

Table 19-2     Bridge LED Blinking Error Codes

LED

Blinking Codes

Description

First
Digit

Second Digit

Ethernet

2

1

Ethernet cable problem—verify that the cable is properly connected and not defective. This error might also indicate a problem with the Ethernet link. If the cable is connected properly and not defective, contact technical support for assistance.

Radio

1

2

Radio not detected—contact technical support for assistance.

1

3

Radio not ready—contact technical support for assistance.

1

4

Radio did not start—contact technical support for assistance.

1

5

Radio failure—contact technical support for assistance.

1

6

Radio did not flash its firmware—contact technical support for assistance.

 

 

1300 Series wireless outdoor Access Point/ Bridge:

 

If your access point/bridge is not associating with a remote bridge or access point, check the four LEDs on the back panel. You can use them to quickly assess the unit's status. For information on using the LEDs during the installation and alignment of the access point/bridge antenna, refer to the Cisco Aironet 1300 Series Outdoor Access Point/Bridge Mounting Instructions that shipped with your access point/bridge.

 

 

 

 

 

 

R

Radio LED

E

Ethernet LED

S

Status LED

I

Install LED

 

 

Problem Type

LEDs

How to...

Products

Bridge

 

Reference

1400 Series Bridge: Checking the Bridge LEDs

1300 Series wireless outdoor Access Point/ Bridge:Checking the LEDs

1064
Views
0
Helpful
0
Comments