Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Received the "Failed to Load Driver for device entry #[2 or 3]" error message

     

     

    Introduction

    Error Message Appears for Access Points with One Radio

    Resolution

    When you install VxWorks firmware version 12.03T in an access point with one radio, an error message appears. If your access point contains only the internal 2.4-GHz radio, this error message appears:

    ** Failed to Load Driver for device entry #3.

    If your access point contains only the external 5-GHz radio, this error message appears:

    ** Failed to Load Driver for device entry #2.

    You can ignore these messages. The errors do not appear if your access point contains two radios.

    This error message appears for 1200 series Access Points (APs) with one radio. If you have firmware version 11.50T in an AP with one radio, an error message appears.

    Problem Type

    Error message

    Products

    Access point

    AP 1200

    Reference

    Error Message Appears for Access Points with One Radio

    Version history
    Revision #:
    2 of 2
    Last update:
    ‎08-23-2017 09:30 PM
    Updated by:
     
    Contributors