Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

The Wireless LAN Controller reboots randomly and the "Coverage hole" error message appears

Core Issue

The coverage hole alarm is sent by Lightweight Access Point Protocol (LWAPP) to the Cisco Wireless LAN Controller (WLC) or Access Control Server (ACS) if the clients on the access point (AP) are detected at low received-signal-strength-indication (RSSI) levels.

Resolution

If clients on an AP are detected at low RSSI levels, Cisco lightweight access points send a coverage hole alarm to the Cisco WLC or the Wireless Control System (WCS). This indicates the existence of an area where clients continually get poor signal coverage, without a viable location to which they can roam. Look up the historical record of access points in order to see if these alarms are chronic, which indicates the existence of a persistent coverage hole as opposed to an isolated problem. If the historical record information of access point is valid or correct then the Cisco Wireless LAN Controller adjusts the access point power levels in order to correct the detected hole. If not, accurate location information can be used in order to help rectify the problem.

Refer to Using Radio Resource Management to Deliver Secure and Reliable WLAN Services for more information on Radio resource management.

Problem Type

Continuous reboot

The signal is weak or fluctuating

Error message

Products

Wireless LAN Controllers

Lightweight Access Points

Topology

LWAPP network

Wireless Devices Errors, Warnings, Statistics and Log Messages

Wireless LAN Controller Errors, Warnings and Log Messages

SW Features

Lightwieght Access Point Protocol (LWAPP)

Version history
Revision #:
1 of 1
Last update:
‎06-22-2009 05:06 PM
Updated by: