Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Uploading an AP configuration through the CLI fails

Resolution

Occasionally, the connectivity to the Access Point (AP) is lost when trying to upgrade the configuration through the Command-Line Interface (CLI) just after the new IP address is configured on the AP through the CLI. To avoid this problem, add the IP address of the Bridge-Group Virtual Interface (BVI) as the last statement of the configuration files, so that the connectivity is not lost until the full configuration is uploaded on the AP.

For more information on the CLI, refer to Using the Command-Line Interface.

For more information about the IP address and BVI interface, refer to the Assigning an IP Address Using the CLI section of Configuring the Access Point for the First Time.

Problem Type

Upgrade

Products

Access point

Product OS

VxWorks

IOS

Version history
Revision #:
1 of 1
Last update:
‎06-22-2009 05:32 PM
Updated by: