Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

User receives the "128bit isn't supported on the Access point" error message during the configuration of the WEP on the WLC

Core Issue

This error message appears when 128-bit encryption is used in place of the 104-bit encryption.

Resolution

This 128bit isn't supported on the Access point error message is seen on controllers when the key lengths shown are actually the number of bits that are in the shared secret and do not include the 24-bits of the IV. Many products, which includes the Aironet products, mention a 128-bit WEP key when in reality, it is a 104-bit key with 24-bit IV. On the controller, the key size of 104-bit is 128-bit.  The 128-bit key size on the controller is actually a 152-bit key. So in order to set the 128-bit key, set with the 104-bit.


Note:
Users are not able to run Wi-Fi Protected Access 2 (WPA2) and static Wired Equivalent Privacy (WEP) on the same WLAN. By default, WPA2 uses Advanced Encryption Standard (AES) for encryption. Users can create two WLANs, one with WPA2 and one with static WEP and assign them to the same interface on the controller.


Refer to these documents for more information:

Problem Type

Configure / Configuration issues

Error message

Products

Wireless LAN Controllers

Lightweight Access Points

Version history
Revision #:
1 of 1
Last update:
‎06-22-2009 04:02 PM
Updated by: