Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

WLCCA Feature Requests

WLC Config Analyzer Feature Tracking

Updated: 22-April-2014

 

Converged Access support

IDTo do item/feature requestETAStatus
1NGWC: Add multicast/multicast config detection
AI: Seema to add more details on detection logic 
3.4 
2NGWC: Detect missing virtual IP address in web auth configuration
AI: Madhu to provide more details
3.4 
    

 

New Checks

IDTo do item/feature requestETAStatus
1Report error if more than one interface has native vlan 0, and using non-lag scenario. This is unsupported scenario for IPv6 clients3.3 
    

 

New Features

IDTo do item/feature requestETAStatus
1

Add parsing and config comparison between controllers for:

Clean Air Solution Setting
Air Quality Settings
Interference Device Settings
CleanAir ED-RRM Settings 

3.4 
2Flexconnect group support
Add parsing and config display for flex connect groups
3.3 
3Compare vlan mappings for APs on same flex connect group3.4 
4Client SNR/RSSI distribution graph3.2Implemented  SNR in beta 3.2.3
5BYOD Audit3.4Check policies under discussion/development
6Best Practices 2.0 Implementation3.2Partially implemented in 3.2.2

 

 

 

Version history
Revision #:
1 of 1
Last update:
‎04-22-2014 05:52 AM
Updated by:
 
Everyone's tags (1)
Comments
New Member

I have two feature requests:

1. 8.0 support (obviously).  Getting "parsign" (spelling error; feature request 1a? :D) errors for QinQ configuration and capwap prefer mode

2. CCA recommends AVC on a vWLC which isn't supported.  Maybe a check for this?