cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
901
Views
0
Helpful
0
Comments
TCC_2
Level 10
Level 10

Resolution

Unfortunately, Wireless LAN Solution Engine (WLSE) does not support any device that is converted from lightweight to autonomous mode, even when it is already on Cisco IOS . The reason for this problem is that, lightweight access points (APs) were made to be managed by the wireless control system (WCS) and the autonomous APs were made to be managed by the WLSE, and this is written on the bootloader for each AP, which no one can change. Even when APs are converted, you can have that access point work as an autonomous, and configure it on Cisco IOS, you are never able to manage them with the WLSE.

Refer to the Using WLSE Configuration Templates for Network Management Set up section of Configuring Access Points for Network Management for more information on WLSE configuration.

Problem Type

Device cannot register

Products

CiscoWorks Wireless LAN Solution Engine (WLSE) Express

LAP 1200

Access point

AP 1200

CiscoWorks Wireless LAN Solution Engine (WLSE)

Product OS

IOS

SW Features

Autonomous mode

Lightwieght Access Point Protocol (LWAPP)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: