350 Non-Root Bridge logging "Started driver for port "fec0" "

[rouven.heim]

Hi!

The non-root bridge (11.23T) which is connected to a Dual-Speed Hub send about every minute the message to my syslog server:

BR350-JM-AKV (Info): Started driver for port "fec0"<000>

BR350-JM-AKV (Info): Stopped driver for port "fec0"<000>

I´ve tried to set the ethernet speed to different settings and I´ve tried a 3COM office Connect Switch and a NetGear Switch. The message still occurs.

On the Root Bridge (11.23T) side, which is connected to an cisco 3524XL, this message doesn´t appear.

Any help would be appreciated!

Thank you,

Rouven

[s.jankowski]

This sounds like you may need to set the non-root bridge back to factory defaults and reconfigure the device. You can reset the device by consoling into it and powering it off then back on and once the device goes through the boot up, type ":RESETALL".