Aironet 3602i with autonomous image will not broadcast SSID

[datrob]

I have some Aironet 3602i APs converted from LWAPP to automous mode and I cannot get the SSID's broadcasted. I can confirm that the radios are active and transmitting (I see their MAC addresses on unnamed signals inSSIDer).

I've made an SSID in the Security options, and selected which radio they apply to. Other than that, I'm not sure on most of the other security settings and what I need to get these to work. This is my first configuring an AP of this complexity, and I am probably doing something wrong.

Would appreciate any advice.

[Sandeep Choudhary]

Hi,

dot11 ssid XYZ

vlan 100

authentication open
mbssid guest-mode <– Only required multiple SSID to be broadcast.

Or

ssid guest-mode  --> If it is only single SSID this needs to be broadcasted.

More check here the config:

http://mrncciew.com/2012/10/24/multiple-ssid-config-on-autonomous-ap/

Regards

Dont forget to rate helpful posts