Wireless

Hello all, I was hoping to gets some feed back on an 802.1x authentication problem I ran into recently. User authentication for a new 802.1x SSID is not working properly for windows computers. However, it can work on devices like cell phones.  Backgr...

Hello! We currently are happily using like 8 aironet AP's (1242ag & 1200 models) for providing a guest-WLAN for our company Headquarter.They all run in standalone mode (root APs). Now we are thinking about providing a second SSID that points to anoth...

Hi everyone.I dont understand the difference betweem these terminologies((( AP can be only in bridge mode. And how this mode can be transformed to these three topologies - I dont undestand. Please help...

I'm trying to run a report on all of the controllers' interfaces that map to WLANs that PI 2.0 knows about.  I can't seem to find the right report, so was wondering if anyone has tried it and found the right way to attain the information.

Dears,Kindly I have a Cisco WCS configured now I brought Cisco MSE3310 and I need to configure it for IPS, so please can you support me with configuration procedures for the configuration specially for the IPS and how is it will work.Thanks for your ...

Hi Experts, Before proceeding for adding AP model 1131 and 1252 into my set-up , I need to know whether any limitation of firmware or hardware for QoS configuration in wireless set-up . I have 4400 controller and 1130 & 1250 AP models.  

Hello all first I'd like to admit I'm not a Cisco guru at all I have limited knowledge of Cisco devices but a customer of ours has a Model 5508 Wireless Controller and he's having an issue with it receiving requests from there DHCP server. Also if th...

Hi everyone.In our office we have a problem with Cisco WLC 2504 and 5 Cisco AIR-CAP2602. Everything works very good for some time, but after half an hour after connection starting problems - speed going down, and latency became very high, also wi-fi ...

Hi,I have a Cisco AIR-LAP1262N-E-9 but I cannot access via console and GUI. Also, I noticed that after getting IP address from DHCP server, its IP address will be released after 2minutes. Then after a while, the access point will get another new IP a...

Hi,We have two Cisco 2602i devices installed in our network and around 90+ users are simultaneously connected over the network. In order to tighten the network with loop holes need to configure some features on these standalone devices.1. Configure W...