Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello I have 2 WLC in my company, 1 is backup of the other one.When i first connect the AP to the network, it is getting attached to the backup one, how can i cange it?However, the AP is connected in the same network of my production WLC, also,  when...

I have a new from the box 5508 which I am attempting to follow the initial setup process to IP it. When I make it through the initial setup the box reboots buts brings me back to the "terminate auto-install" prompt again for some weird reason?Any ide...

Greetings,I have a strange scenario I have been brought into at work. A loading dock that has 3 Cisco 1242ag units started filling the spectrum with noise keeping their set channel at 100% duty cycle. I'm using Cisco Spectrum Expert to locate the dev...

Allthought AIR-LAP1252AG-T-K9 has gigabit 0 configured to  "speed auto" it joins 6509 giga port as Full-duplex, 10Mb/s. AIR-LAP1252AG-T-K9 configutaion: #sh run int gigabitEthernet 0interface GigabitEthernet0 ip address dhcp client-id GigabitEthernet...

Resolved! 5760 IOS

 Hi Experts, I have 5760 with code 3.2.3SE and this does not support HA AP SSO.  The code that will support HA AP SSO is 3.3.x.  There is a latest code 3.6.0E available.  For the 3.3 train, the latest is 3.3.4SE.  Which code should I upgrade to?  Reg...

mcaoile by Level 1
  • 328 Views
  • 2 replies
  • 0 Helpful votes

Hi, we're using a virtual Wireless LAN Controller (WLC) v7.5.102.0 and virtual Identity Service Engine (ISE) v1.2.0.899.All APs run in flexconnect mode, sometimes it happends that wireless clients are unable to associate with the AP (usually when it'...

jheuke007 by Level 1
  • 2945 Views
  • 3 replies
  • 0 Helpful votes

Hi I am looking to mesh two 1242 or 2602 access points together.  I am in a mine environment which completely decimates 5ghz signals.  Therefore I need to connect the two APs using 2.4ghz.  Is my only option to buy 1522 APs?  I am currently getting a...

  Hi.. I am running virual WLC on VM server, now i need to shift WLC on another VM server. Is there any way to take backup of existing virtual WLC. How could i achieve this.Pls help..

Anukalp S by Level 1
  • 1497 Views
  • 3 replies
  • 0 Helpful votes