Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.

Wireless

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Labels

Forum Posts

Start a conversation

Resolved! Strange AP2602i behaviour on WLC2504 7.3.112

Hi Guys.There are two Cisco WLCs 2504 running 7.3.112 release. Both WLCs has a minimal configuration difference (AP groups/ IP addresses).There is a problem with only one AP2602i (there was no problem with this AP before. Other 20 APs works without a...

EvaldasOu by • Level 4
  • 1045 Views
  • 11 replies
  • 0 Helpful votes

how to see Access point Neighbor

hi All,how to see an Access point neighbor from WLC.Code 7.4.110             i logged in to the CAP3501 - console but i dont know any command. I want to know which accesspoint is near by and the channel operation.

Resolved! Mobility Group Issue

Hi All,I think a MAC address might be mistyped in the MG list on one of our 5508 WLC's. - What is the command that will display the controllers proper MAC address so that I can validate. I have tried all of the commands that I know of. Would it be th...

Resolved! MSE Connectivity Problem

Hi All, I am having a problem getting my MSE joined to my WCS. It was joined at one point, but we changed the IP address on the eth0 interface from one IP to another and now it's showing up in WCS as UNREACHABLE. I have run through the setup of my MS...

PrimeNCS and Domains

Good Afternoon All,We use a WISM2 Controller for our "Flexconnect" deployment out to our Districts. We started usingthe Domain feature to allow our districts to manage their own domain. Create Guest users, Rename AP's etc.When we used Cisco WCS, We a...

Resolved! Can autonomous and LAPs co-exist?

I have an existing roaming 2.4 wireless network which consists of 4 autonomous 1242 APs. I need to expand the coverage area.Can I add a controller and LAPs with the same SSID and expect my clients to roam from the autonomous AP to the LAP?Or do I nee...

Roaming Doubt

hi All,I have a doubt on how roaming works.I have AP's and AP Groups2 WLCAll Access points associated to same WLCAP Group 1 - Subnet A - VLAN 1AP Group 2 - Subnet b - vlan 2Now if a user roams from APGroup 1 --> APG2 , means in diff subnet. What will...

Resolved! 5508 WLC Interface Groups

We have not configured or used interface groups in our wireless deployments, and I am just curious if there are any issues or caveats experienced with using these?  We have a few instances where we have setup a /23 network for a specific wlan.  I  un...

awatson20 by • Level 4
  • 729 Views
  • 3 replies
  • 0 Helpful votes

wlc 5760 - web authentication

Hello, I want to configure web autentication on my WLC.      - users will connect to SSID      - once they are connected they will be redirected to a web page asking for username and password     - i want to use the LDAP username and passwords for th...

Aironet 1600 + Freeradius + openLDAP

Hi at all,i need to know if is possible to have this kind of configurations, because I'm going crazy to test it and nothing work.I've freeradius attached to OpenLDAP with user and password crypted with SSHA, but the Aironet don't want to authenticate...

View All
Review Cisco Networking products for a $25 gift card