Wireless

I have multiple controllers all configured with the same WLAN/SSID, like most people probably do.  I am trying to get a report on one WLAN/SSID from only one controller.  I don't want a report for the WLAN/SSID that contains information from all cont...

Hi,I have 50 SSL Premium licenses on my ASA 5520 running 8.4. I want to run Anyconnect on IPAD- and IPHONE-devices but it seems that this requires a Mobile-license on top of the premium-license. Is it possible to receive an evaluation-license for thi...

Hi,I need to secure communication between Wireless Controller and AP using Certificate. Currently am planning to use LSC is there is another way to secure AP communication to WLC other than Authorize AP against AAA and LSC. because in both these sena...

Hi,I have 4 WiSM and 8 controllers and around 600 AP's. Currently ereything is working fine. Now I need to implement security and as a result am planning to authenticate my AP;s against AAA. We have 2 ACS 1113 running in 4.2. I am using the following...

Hi,I have a 4402 (version 7.0.235) working with 10 units of 1121 APs connected to it. The WLC is not configured to work in LAG mode. Physical portt #1 is connected to the Main Switch (trunk). I have 3 WLAN mapped to 3 Different VLAN and Everything (s...

Dear All,I need a advise on this. Basically at home i am using normal sky router and the wireless signals are really bad in the kitchen and garage area. I want to put a device which helps in better signals. Could you please give me some suggestion ab...

Hi,Would appreciate some advice, I am using a 5508 controller, I have an SSID that has WMM enabled and platinum QoS profile applied, with default settings.  I have 802.11p set to none as we are not doing layer 2 QoS on the switches.I found that when ...

Hi,I have faced with the strange issue.After I've upgraded software to the v7.3 and applied AP-SSO it made imposible to access the controller's gui via Service-port. So we tried to access it by management-port, but there is some problem too. It is no...

Hi All,Warm Greetings,we have Scheduled an Upgrade for 2 of our WLC Controllers 4402 From Software Version 6.0.182.0 to 7.0.235.3 Version.I Have gone through the Cisco Docs for the upgrade procedure, I have an Doubt, When i Downloaded the WLC softwar...

Hello,Is it possible to turn down a signal on a single wap, for a single wlan on a controller?                  

HiWe have Cisco 3501i access points in our network.I want to connect with 3550 switch but access point is not working and getting the below errorcontroller port error.IOS image --=c3550-i9q3l2-mz.121-20.EA1a.binSwitch Model---WS-C3550-24PWR-SMII want...

Hello all,This problem only seems to affect one of our sites.  Every once in a while, several APs would lose link to the 5508 and get stranded.  The only way to fix the issue is either to power cycle, or better yet SSH into the APs and use the comman...

When I open Monitor - Site Maps - <building map> you can select a number of options on the left hand side for Access Points.I have selected utilisation as I wanted to see which APs were being used heavily on the b/g/n radio.Now what I'm seeing in som...